Eracast Mould Release 1L
$56.60 + GST
Out of stock
Dangerous Goods – Shipping Surcharge Applies
Salease is a low viscosity liquid mould release agent based on heavy-duty silicones. It gives excellent release characteristics for simple and complex potting, casting and moulding operations.
Salease releases polyurethane, epoxy, polyester and most other polymers, regardless of catalysts and fillers, from metals, polymers and any other non-porous moulds. It works equally well at room temperature and at elevated processing temperatures.
Salease leaves a thin film of silicone thus allowing reproduction of the finest detail.
Colour Clear Specific gravity at 20o C (g/cm3 ) 0.73 Flashpoint -4o C
Apply Salease to clean moulds by dipping, brushing or spraying. Drain excess release agent from the mould and air-dry between 5 and 10 minutes (less at elevated temperatures). For optimum surface results, lightly buff the inside of the mould with a clean, lint-free cloth after drying. It is not necessary to reapply Salease after each demould cycle. Periodically clean moulds to remove any dirt or build-up with a suitable solvent depending on mould material.