Trinic Tough Finish 2 Matte (946ml)
$165.00 + GST
Available on backorder
Trinic Tough Finish 2
- Use Indoors or Outdoors / UV stable will not yellow
- Increase abrasion resistance
- Increase stain resistance
- Can be used over most other sealers/ coatings
- Easy application / Spray / Roll/ Mop
- Can be spot repaired / Buffed / Re-applied / No stripping needed
- Anti-skid version available for floors/ stairs and wet areas.
- Eliminates the need for wax.
Coverage Rate: 25sqm
Surface Preparation: Surface must be clean and free of debris, oils, loose sealer or coatings, soap and cleaning residues must be removed prior to application. A test area application is suggested.
Application: Once surface is clean TF -2 can be applied by pump spray and back roll with a short nap roller or use a paint pad or microfiber mop. For countertops a microfiber pad works well. Spread a thin layer of TF-2 following the suggested coverage rate and allow to dry for about 4-5 hours. Fans can be used to circulate air and expedite the curing process. Avoid over application it will cause a decrease in abrasion resistance and longer cure time.
Cure Time: Surface should be read y for light traffic in about 4-hour s, full cure is 24 hours.
Post Application Care: To achieve a high gloss finish use a slow speed buffer and white Scotchbrite or lamb’s wool pad (buffing compounds can assist with the process but are not required) Clean surface with Non-Abrasive, non- acidic cleaner.