Trinic Tough Finish 2

$165.00 + GST

In stock

SKU: 545 Category: Tags: , ,


Trinic Tough Finish 2

  • Use Indoors or Outdoors / UV stable will not yellow
  • Increase abrasion resistance
  • Increase stain resistance
  • Can be used over most other sealers/ coatings
  • Easy application / Spray / Roll/ Mop
  • Can be spot repaired / Buffed / Re-applied / No stripping needed
  • Anti-skid version available for floors/ stairs and wet areas.
  • Eliminates the need for wax.

Coverage Rate: 25sqm

Surface Preparation: Surface must be clean and free of debris, oils, loose sealer or coatings, soap and cleaning residues must be removed prior to application. A test area application is suggested.

Application: Once surface is clean TF -2 can be applied by pump spray and back roll with a short nap roller or use a paint pad or microfiber mop. For countertops a microfiber pad works well. Spread a thin layer of TF-2 following the suggested coverage rate and allow to dry for about 4-5 hours. Fans can be used to circulate air and expedite the curing process. Avoid over application it will cause a decrease in abrasion resistance and longer cure time.

Cure Time: Surface should be read y for light traffic in about 4-hour s, full cure is 24 hours.

Post Application Care: To achieve a high gloss finish use a slow speed buffer and white Scotchbrite or lamb’s wool pad (buffing compounds can assist with the process but are not required) Clean surface with Non-Abrasive, non- acidic cleaner.